Lapp Solar Cable showing Strands
Lapp Solar Cable
Solar Cable 6.0mm Black .
Solar Cable 6.0mm Black main colour plus Red stripe.
For outdoor applications

Reduction of flame propagation and of toxic combustion gases in the event of fire

Eca classified per CPR

25 years in expectable lifespan under normal use conditions as defined in EN 50618

Improved resistance in salt-containing air and close to salt water bodies.

For free and stationary or for freely suspended outdoor and indoor cabling between the solar modules, or between the module strings and the DC/AC inverter, for example in line with HD 60364-7-712 on PV systems, and EN 50618 on H1Z2Z2-K cable type, etc....; Short circuit and earth fault protected per EN 50618, Annex A, and per HD 60364-5-52.

As per EN 50618, Annex A, inside electrical installation pipe/ duct/ channel, plaster, and appliance, as well as inside or connected to double insulated/ protected appliance or system of protection class II

Photovoltaic systems with DC system voltage up to 1800 V to ground

Underground use without protection conduit/ duct in professionally built cable trench with at least 50 cm of back-fill soil (70 cm underneath roads), above indicating tape, above covering plastic slab, above at least 10 cm of covering sand layer, above the cable laid on at least 10 cm high sand bed layer (cf.: Section 4.2 of VDE 0891-6, or Section 300.5 in Article 300 of NFPA 70/ NEC - National Electrical Code of the USA). Underground laying inside buried conduit/ tube/ pipe/ raceway, where waterlogging is carried off, out of the protection system, and where any water intruding the protection system is not contaminated

Permanent contact with uncontaminated freshwater, under mechanical protection; Conditional usability in limitedly salt-containing air, for instance close to salt-containing water bodies.

Weather/ UV resistant per EN 50618, Annex E, as well as ozone resistant per EN 50396

Flame retardant per IEC 60332-1-2, and Eca classified per EU CPR - Construction Product Regulation (EU) No. 305/2011

Halogen-free according to IEC 60754-1 (amount of halogen acid gas), Low Corrosiveness of combustion gases according to IEC 60754-2 (degree of acidity)

AD8 - Permanent Submersion

Salt mist resistance test acc. to DIN EN 60068-2-11, test Ka, sections 3.1.2 and 3.2; Ammonia resistance test per EN 50618; Long-term water immersion test based on EN 50618 and EN 50395; AD8 test series per EN 50525-2-21, annexes D and E.

H1Z2Z2-K type certified according to EN 50618
Fine-wire, tinned-copper conductor

Naturally coloured conductor insulation made of electron-beam cross-linked co-polymer polyolefin (XLPO)

Outer sheath made of electron-beam cross-linked, halogen-free co-polymer polyolefin (XLPO)

Outer sheath colours:

#38001014: Black only

#38001015: Black main colour with red, longitudinal stripe